PTO Power Take Off

PTO Power Take Off

PTO or Power Take Off on your tractor makes it a wonderful machine. This gives you the option of running different implements to do various task. The most common is the rotary cutter. You will need to engage the pto some how. This usually requires pushing the clutch of the tractor down as far as it will go and then moving a lever to engage the pto shaft coming out the back of the tractor or just moving a lever, knob or switch. Now whatever you have on the PTO power take off will start doing what it is intended to do. When disengaging you do the steps in reverse.

Also there is the choice of the live pto and independent pto. I wouldn’t say one is better than the other. I think it is more personal preference and how you will use the tractor. One will stop receiving power when the clutch pedal is push down and the other will not. When using an independent you normally do not have to engage the clutch to use it where as a live you must fully press the clutch pedal as far as it will go to engage both the transmission and the pto clutches at the same time. The hydraulic independent clutches are real nice. Just flip a switch or turn a knob and your done.

Now there is the older models where the pto drives directly through the transmission and if the implement doesn’t stop neither does the tractor. In this case you would need anĀ over run clutch so the rotary cutter doesn’t push the tractor off a cliff while you are on it.

Basic rule of thumb is 5 horsepower for every foot of implement. There is a difference between engine and pto horsepower. If you have a 6 foot rotary cutter you will need 30 pto horsepower. Hope this helps.

Rotary cutter and tractor from the rear of the unit with the pto shaft hooked up.

 

 

How Much Tractor Do I Need?

How Much Tractor Do I Need?

How much tractor do I need? That is a good question. There is a lot of things that can make this decision or break it. Lot of times more is better, but not always. If you have 5 to 100 acres something with 35 to 50 horse power is usually plenty. Of course this does depend on the use of the unit as well. I think as long as you can manage 5 – 6 foot implements you will be fine.

One thing to keep in mind is weight. One deciding factor in us buying a tractor was we wanted the ability to stack round bales if necessary or to be able to off load round bales from a trailer. So lifting height and capacity of the front end loader did play a factor in our decision. If not for that we could have picked a smaller unit for our farm. At the time of this article we have a 4 wheel drive 4025 Mahindra. Believe me it is plenty for a small farm. Now that we have customers a little more under the hood would be nice.

Always keep in mind when it comes to tractors more power doesn’t mean you can go faster when doing a job. It means that you can run bigger implements, attachments or not bog down as much running smaller ones. You may gain a little speed, but odds are your travel speed will remain the same.

Here you can see in the video below that with 41 engine horsepower and 31 pto (power take off) we can run a 6 foot rotary cutter through some serious stuff. So bigger is better, but not necessary if you have the time to go slower. The canopy on the tractor is approximately eight feet off the ground to give you an idea of what is being tackled on the jobs we do.

Side shot of the berm.