PTO Power Take Off

PTO Power Take Off

PTO or Power Take Off on your tractor makes it a wonderful machine. This gives you the option of running different implements to do various task. The most common is the rotary cutter. You will need to engage the pto some how. This usually requires pushing the clutch of the tractor down as far as it will go and then moving a lever to engage the pto shaft coming out the back of the tractor or just moving a lever, knob or switch. Now whatever you have on the PTO power take off will start doing what it is intended to do. When disengaging you do the steps in reverse.

Also there is the choice of the live pto and independent pto. I wouldn’t say one is better than the other. I think it is more personal preference and how you will use the tractor. One will stop receiving power when the clutch pedal is push down and the other will not. When using an independent you normally do not have to engage the clutch to use it where as a live you must fully press the clutch pedal as far as it will go to engage both the transmission and the pto clutches at the same time. The hydraulic independent clutches are real nice. Just flip a switch or turn a knob and your done.

Now there is the older models where the pto drives directly through the transmission and if the implement doesn’t stop neither does the tractor. In this case you would need anĀ over run clutch so the rotary cutter doesn’t push the tractor off a cliff while you are on it.

Basic rule of thumb is 5 horsepower for every foot of implement. There is a difference between engine and pto horsepower. If you have a 6 foot rotary cutter you will need 30 pto horsepower. Hope this helps.

Rotary cutter and tractor from the rear of the unit with the pto shaft hooked up.